2 Stripes Tricaster Panel

A

alonso

Member
Hello friends
Question, is there a way that we can setup the 2 stripes panel in a way that The stripe to the top control bank 1, and the stripe on the bottong bank 2?
We have several inputs on our tricaster, so we need to switch very fast in some situation, and press bank button and the the source is too slow sometimes
 
I can't recall if this feature is on all TriCaster models, but if it is available on your model, you can do it by performing the following steps.
  1. Delegate the upper and lower stripe to the same bus.
  2. Then press and hold the CTRL and ALT keys on the 2S surface.
  3. In the LCD readouts you will see the three banks listed.
  4. Press the KEY ROW button (above) the LCD readout to force that stripe to a bank. (If no key button is lit up, then the bank will follow the 1, 2 or 3 bank selection).
 
You must log in or register to reply here.
Back
Top